References
Data Editing
When a barcode is scanned, additional information can be sent to the host
computer along with the barcode data. This combination of barcode data and
supplementary user-defined data is called a "message string." The Data Editing
features can be used to build specific user-defined data into a message string.
There are several types of selectable data characters that can be sent before
and after scanned data. You can specify if they should be sent with all symbol-
ogies, or only with specific symbologies. Figure 15 shows the available ele-
ments you can add to a message string:
Figure 15. Breakdown of a Message String
Please Keep In Mind...
•
•
•
•
296
It is not recommended to use these features with IBM inter-
faces.
CAUTION
Label ID Transmission:
Enable this option to
transmit the Label ID you
configure for the scanned
symbology.
Prefix
Label ID
AIM ID
Additional advanced editing is available. See the Advanced formatting fea-
tures in the Datalogic Aladdin configuration software, or contact Technical
Support (described on
Modifying a message string is not a mandatory requirement. Data editing
is a sophisticated feature allowing highly customizable output for
advanced users. Factory default settings for data editing is typically set to
NONE.
A prefix or suffix may be applied only to a specified symbology (reference
Code Selection, starting on page
the Global features in this chapter).
You can add any character from the
back cover of this manual as a prefix, suffix or Label ID.
Enter prefixes and suffixes in the order in which you want them to appear
on the output.
Bar Code Data
AIM ID: This function is used to identify and display the
common label identifier for its symbology. When enabled,
this ID code will be transmitted before the scanned bar
code data.
00 - 20 Characters (ASCII)
page 11
for more information.
111) or across all symbologies (set via
ASCII Chart
Gryphon™ I GD4132/GM4102/GBT4102
OR...
Label ID
Suffix
(from 00-FF) on the inside