Reading Configuration Barcodes - Datalogic Gryphon I GD4132 Product Reference Manual

Configuration Using Barcodes
Symbology-specific parameters:
•
Model-specific parameters:
•

Reading Configuration Barcodes

To program features:
1. Scan the ENTER/EXIT PROGRAMMING barcode, available at the top of each
2. Scan the barcode to set the desired programming feature. You may need
3. If additional input parameters are needed, go to
4. Complete the programming sequence by scanning the ENTER/EXIT PRO-
For detailed descriptions, programming information and examples for setting
selected configuration items, see
40
"Code Selection" on page 111 provides configuration of a personalized
mix of codes, code families and their options.
"Wireless Features" on page 259 offers configuration of radio control
parameters for RF and Bluetooth models.
You must first enable your reader to read barcodes in order to use
this section. If you have not done this, go to
page 17
programming page, when applicable.
to cover unused barcodes on the page, and possibly the facing page, to
ensure that the reader reads only the barcode you intend to scan.
scan the appropriate characters from the keypad.
Additional information about many features can be found in the "Ref-
erences" chapter.
If you make a mistake before the last character, scan the CANCEL bar-
code to abort and not save the entry string. You can then start again
at the beginning.
GRAMMING barcode to exit Programming Mode.
and complete the appropriate procedure.
References, starting on page
Gryphon™ I GD4132/GM4102/GBT 4102
Setup, starting on
Appendix D, Keypad, and
283.