Sleep Mode Timeout; Sleep Mode Timeout - Datalogic Gryphon I GD4132 Product Reference Manual

Sleep Mode Timeout

This feature sets the amount of time that the reader will be idle before it enters
into a low power Sleep Mode. When in Sleep Mode the reader can no longer
receive commands from the Host or base station until it is woken up again by a
trigger pull or being placed into a base station.
In order for the reader to enter Sleep Mode, the following conditions must be
met:
Corded version (GD4132
ple or trigger pulse.
Mobile version (GM4102
the base) when trigger single, trigger multiple or trigger pulse are set, and
when the reader is not charging the battery.
Sleep Mode Timeout = Disable
Sleep Mode Timeout = 2 Seconds
$
Sleep Mode Timeout = 4 Seconds
98
RS-232 interface and trigger single, trigger multi-
only):
Sleep state is allowed only on the handheld (not on
only):
This feature is not applicable to the Gryphon BT models
ENTER/EXIT PROGRAMMING MODE
DEFAULT
Sleep Mode Timeout = 1 Second
Sleep Mode Timeout = 3 Seconds
Gryphon™ I GD4132/GM4102/GBT4102