Bt-Only Features - Datalogic Gryphon I GM440 Series Product Reference Manual

References

BT-Only Features

BT Pin Code
This option specifies the 4-character or 16-character pin code to be used
for authentication of the BT
1.
2.
3. Determine the desired characters. For example, D254 or
4. Convert the characters to hexadecimal using the
5. Go to
6. Scan the appropriate alphanumeric characters from the keypad in
7. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
Table 23. BT Pin Code Setting Examples
STEP ACTION
1 Desired Setting
Convert the characters to
2
hexadecimal
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SET BT PIN CODE
Scan 8 or 32
Alphanumeric
5
Characters From
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
296
Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
ming Mode, then enable
Specify the desired pin code length (4 or 16) by scanning the appropri-
ate bar code in "Select PIN Code Length"
STOR12345678135M
inside back cover of this manual.
page 252 and Scan the bar code: SET 4 CHAR PIN CODE or SET
16-CHAR PIN CODE.
Appendix D, Keypad, representing the hexadecimal entries determined
in the steps above. You will hear a two-beep indication after the last
character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
ming Mode.
Changing the pin code setting will unlink the devices. If the Automatic
Configuration Update is set to the default enabled setting, the devices
must only be relinked. If the Automatic Configuration Update is set to the
disabled setting, the Pin Code setting must also be updated in the Base
Station using Aladdin. After the Base Station has been updated, the
devices must be relinked.
EXAMPLES
D254
44 32 35 34
44323534
link. To set the pin code:
"BT Security Mode"
on page 252.
STOR12345678135M
53 54 4F 52 31 32 33 34 35 36 37 38 31 33 35 4D
53544F5231323334353637383133354D
Gryphon™ I GD44XX/GBT4400/GM440X
on page 251.
ASCII Chart on the