Installing The Interface Cable - Datalogic Gryphon I GD4132 Product Reference Manual

Setup

Installing the Interface Cable

For Corded versions,
handle as shown in
aperture, then unplug the cable.
Figure 2. Connect/disconnect the cable
RS-232 Serial Connection
Turn off power to the
terminal/PC and connect the reader to the terminal/PC serial port via the RS-
232 cable as shown in
the Terminal) to supply reader power, use the approved power supply (AC
Adapter). Plug the AC Adapter barrel connector into the socket on the RS-232
cable connector and the AC Adapter plug into a standard power outlet.
Figure 3. RS-232 Connection
18
connect the reader cable by inserting the cable into the
Figure 2. To remove it, insert a paper clip into the release
Figure 3. If the terminal will not support POT (Power Off
Gryphon™ I GD4132/GM4102/GBT 4102