Datalogic Gryphon I GD4132 Product Reference Manual page 304

References
Table 39
STEP ACTION
1. Scan the ENTER/EXIT barcode
Determine placement of the
Label ID characters BEFORE or
AFTER with regard to scanned
2.
data using Label ID
Control, starting on page
84
Scan the barcode selecting the
symbology type you wish to
designate label ID characters
for using Label ID
3.
Symbology
Selection, starting on
page 85 .
Custom Label ID example
4.
(desired characters):
Find hex equivalents from the
ASCII Chart (inside back
cover), then scan in these
digits/characters using the
barcodes in the section:
Keypad, starting on page
5.
337 . If you make a mistake
before the last character, scan
the CANCEL barcode to abort
and not save the entry string.
You can then start again at the
beginning.
6. Scan the ENTER/EXIT barcode
Scan the ENTER/EXIT barcode
7.
once again
Result:
302
. Label ID Examples
EXAMPLES
Enable as Prefix Enable as Suffix Enable as Prefix
DataBar
Omnidirectional
D B *
44 42 2A
DB*[barcode
data]
(Scanner enters Programming Mode)
Code 39 Interleaved 2 of 5
= C 3 +
3D 43 33 2B
(Scanner exits Label ID entry)
(Scanner exits Programming Mode)
[barcode
+[barcode data]
data]=C3
Gryphon™ I GD4132/GM4102/GBT4102
Enable as Suffix
Code 32
P H
50 48
[barcode data]PH