Two-Point Lap Belt With Metal Buckle, Padded - Otto Bock Kimba Neo Instructions For Use Manual
Hide thumbs
Also See for Kimba Neo:
- Instructions for use manual (60 pages) ,
- Service manual (44 pages) ,
- Instructions for use manual (56 pages)
Table of Contents
Advertisement
Instructions for use
•
Place the user in an upright, 90° seated position (if physiologically possible).
•
Ensure that the back is up against the back support pad (if physiologically possible).
•
The positioning belt, which is usually preinstalled, should run in the direction of the thighs in front of the pelvic
bones if possible (not illustrated).
2-point lap belts: The positioning belt should be at an angle of about 60° to the seat surface. The belt strap
•
should run across the thighs in front of the pelvic bones (see fig. 29).
4-point lap belts: The main strap (with padding) should be at an angle of about 60° to the seat surface. The
•
belt strap should run across the thighs in front of the pelvic bones (see fig. 30, item 1).
The retaining straps should be positioned in front of the main strap to hold the main strap in position (see
fig. 30, item 2).
Possible errors
•
The positioning belt is positioned above the pelvis of the user in the area of the soft part of the stomach.
•
The user does not sit upright in the seat.
•
If the positioning belt is too loose, the user can shift/slide out to the front.
•
During the installation/adjustment, the positioning belt is routed over parts of the seating system (e.g. over arm
supports or seat pads). This causes the lap belt to lose its positioning and retaining function.
29
7.2.2.1.1 Two-point lap belt with metal buckle, padded
Adjusting the belt
1) Pull the belt out of the plastic loop (see fig. 32, item 2).
2) Press the belt buckle firmly (see fig. 32, item 1) then pull the belt to the required length.
INFORMATION: Ensure that the belt extends for at least 20 mm beyond the buckle so that it sits
securely.
3) Secure the loose end of the belt by feeding it through the plastic loop (see fig. 32, item 2).
Using the belt
1) Open the belt buckle by pressing the PRESS button (see fig. 31, item 1).
2) Sit the user in the seat.
3) Press the belt tongue into the buckle until engages audibly.
Kimba Neo
60°
30
60°
Use
21
Advertisement
Table of Contents
