Adjusting The Knee Angle; Folding The Leg Support Up And Down - Otto Bock Kimba Neo Instructions For Use Manual

CAUTION
Faulty protective edge band
Cuts caused by exposed metal components
► Ensure that no part of the protective edge band is faulty and that it is not detached from the leg support.
► Have a faulty protective edge band replaced by the dealer.

7.1.5.1 Adjusting the knee angle

The leg support's knee angle can be adjusted in a range of 0° - 90°:
1) Release the clamping lever on the leg support (see fig. 20, item 1).
2) Adjust the knee angle.
3) Tighten the clamping lever.
4) Before using the product, check that the leg support is secure by pressing down on it.
→ The knee angle must not change.
20

7.1.5.2 Folding the leg support up and down

The leg support may be folded up for transporting:
Leg support, standard
1) Hold the leg support by the edge and fold it upwards (see fig. 21, item 1).
2) After transport, fold the leg support down again.
"Angle-adjustable" leg support (option)
1) Pull the release strap (see fig. 22).
2) Hold the leg support by its edge and fold it upwards.
3) After transport, fold the leg support down again. The leg support locks into place automatically.
21
Angle-adjustable leg support for short lower leg lengths (option)
1) Pull the release strap (similar: see fig. 22).
2) Depending on its position after installation, the leg support can be folded down (short lower leg lengths) or up
(standard).
Kimba Neo
22
Use
17