Installing The Crutch Holder; Installing And Adjusting The Lap Belt - Otto Bock Start M2S Instructions For Use Manual

Settings
60

6.12.3 Installing the crutch holder

1) Pre-install the crutch holder for use on the left or right. To do so, attach the cup to the plastic base plate
accordingly using the short mounting screws (see fig. 61, item 1).
2) Insert two mounting screws in the bores of the frame tube above the drive wheel adapter.
3) Mount the crutch holder on the frame tube with two hexagon nuts and spacer washers (see fig. 61, item 2).
Carefully tighten the hexagon nuts.
4) Loosen the Phillips head screw on the back support upholstery (see fig. 62, item 1).
5) Set on the hook-and-loop strap and mount it on the back support tube with the Phillips head screw.
61

6.13 Installing and adjusting the lap belt

CAUTION
Incorrect approach to the adjustment process
Injuries, malpositions, illness of the user due to adjustment errors
► The belt system may only be installed by qualified personnel.
► The qualified personnel is responsible for individual positioning and fitting of the belt system.
► Excessively tight adjustment of the belt system may lead to unnecessary pain or illness of the user.
► Adjusting the belt system too loosely can cause the user to slide into a dangerous position. In addition, the
fastening snaps could open unintentionally if they slide against hard parts of clothing (e.g. buttons).
► For proper installation and adjustment, follow the instructions for use included with the product.
CAUTION
Lack of instruction
Injuries, malpositions, illness of the user due to information errors
► The qualified personnel is responsible for making sure that the user and/or attendant/nursing staff has under­
stood the proper adjustment, use, maintenance and care of the belt system.
► In particular, ensure that the user and/or attendant/nursing staff knows how to quickly loosen and open the
product to avoid delays in case of emergency.
26
62
Start M2S, Start M2