Tilting The Mast Manually; Lowering The Forks Manually - Linde E 20-02 Operating Instructions Manual

Tilting the mast and lowering the forks manually

Tilting the mast manually

NOTE
The overhead guard cannot be opened when the mast is
tilted back.
If a malfunction exists, the mast can be tilted forward
manually.
- Fully lower the fork carriage, if possible.
WARNING
Do not stand in the fork area when the mast is
tilted back.
When the tilt cylinders are bypassed, the mast and forks
can tilt forward.
- Remove the plug (1).
- Insert the screwdriver through the plug opening and fit it
on the cheese head screw (2).
- Slowly turn the screwdriver counterclockwise approx. 2
revolutions.
- Push the mast forward with your hand.
- Disengage the overhead guard.
- Open the overhead guard.
- Turn the cheese head screw (2) clockwise as far as
possible.
NOTE
Immediately screw the cheese head screw (2) back to the
initial position when finished, otherwise the tilting cylin-
der cannot be operated with the control lever.
- Place the plug (1) into its position.
e336-02/16

Lowering the forks manually

NOTE
If a malfunction exists, the forks can be lowered manual-
ly.
- Open the overhead guard to the first lock position or
remove the plug (1).
WARNING
Do not stand near the forks while they are being
lowered.
Leave the screwdriver on the setscrew (5) during lowering
to be able to stop lowering at any time.
- Loosen the locknut (4).
- Using a screwdriver, slowly turn the setscrew (5) anti-
clockwise about 1 turn until the fork carriage is fully
lowered.
- Turn the setscrew (5) clockwise as far as possible, other-
wise the forks cannot be operated with the control lever.
- Tighten the locknut (4).
3
1
e336-02/55
Operation
4 5
e3363415
53