Operation; Driving; Travel In The Forward Direction; Travel In The Reverse Direction - Linde E 20-02 Operating Instructions Manual

Driving

Driving
CAUTION
Travel on long slopes over 15 % is generally not
allowed due to the prescribed minimum brake
applications and truck stability characteristics. Before
driving on steeper slopes, you should consult your
distributor. The climbing ability rates given in the data
sheet were derived from the tractive force of the truck
and they apply only for the crossing of obstacles and for
short differences in level.
NOTE
Always adapt your driving style to suit the conditions of
the roadway (rough surfaces, etc.), especially hazardous
work areas and the load.
ATTENTION
The hydraulic pump motor is switched on when
the steering or the working hydraulics are oper-
ated.
NOTE
All control levers must be in the neutral position.
- Sit down on the driver's seat (only this will actuate the seat
switch beneath the driver's seat).
- Push in the emergency isolator button (4) against the
spring, turn it clockwise to the stop and pull out.
NOTE
On certain Linde fork trucks (eg with container overhead
guard, swivel seat) the torso clearance is reduced.
Therefore only persons with a headroom of 30 mm be-
tween the head and overhead guard should operate this
truck.
NOTE
Only when the proper procedure is followed can the
emergency stop be disengaged and the truck can again
be operated.
30
- Apply the seat belt.
- Insert the key (1) into the switch lock and turn the key
clockwise as far as possible.
- The symbol „h" (8) and the decimal point (9) will flash and
the hour meter (11) is turned on.
The battery discharge indicator (10) and all warning lights
in the composite instrument (2) will be illuminated (warn-
ing lights will extinguish after approx. 2 seconds, except
for warning light (7)).
NOTE
Operate the joystick and/or the drive pedals only after the
indicator lamps (except 7) have extinguished.
Otherwise the truck is switched off.
Switch off and on the key switch to start the truck again.
- Raise the forks slightly and tilt the mast back.
- Release the handbrake (3) (indicator light (7) will extin-
guish).
1
6 5
e336-02/39

Travel in the forward direction

- Depress the right accelerator pedal (5) smoothly. Truck
speed depends on how far the pedal is depressed.
NOTE
Depressing the accelerator pedal fully will not increase
the rate of acceleration as maximum acceleration is
controlled automatically.

Travel in the reverse direction

- Depress the left accelerator pedal (6) smoothly.
Truck speed depends on how far the pedal is depressed.
Truck speed depends on how far the pedal is depressed.
7
2
2
3
11
4

Operation

!
P
8
9
10
335/29