Central Control Lever (Joystick) Operation Of Mast And Attachments; Tilting The Mast Forward; Tilting The Mast Back; Raising The Fork Carriage - Linde E 20-02 Operating Instructions Manual

Central control lever (joystick) operation of mast and attachments

WARNING
Use the lifting device and attachments only for
authorised applications. The operator must be
instructed in the handling of the lifting device and attach-
ments. Observe the maximum lift height. Do not put your
hands or any other part of the body into the lift mast or the
space between the mast and truck.
Always operate the control levers smoothly; do not jerk.
The speed of lifting, lowering and tilting is determined by how
far the lever is moved. The lever is designed to return to the
neutral position when released.
NOTE
Note the operating symbols with arrows.
NOTE
On the single lever model both functions are operated
simultaneously (e.g. lifting and tilting) when the control
lever is moved to an intermediate position (about 45°).

Tilting the mast forward

- Push the control lever (1) forward.
1
36

Tilting the mast back

- Pull the control lever (1) back.

Raising the fork carriage

WARNING
Do not step on the raised forks. Increased danger
of falling and being squeezed.
- Push control lever (1) to the right.

Lowering the fork carriage

- Push control lever (1) to the left.

Operating the attachments

Attachments (e.g. sideshift, clamp, etc.) can be fitted on the
lift truck as optional equipment. Observe the operating pres-
sure and instructions for the attachment. One additional
control lever is fitted for its operation.
NOTE
For each attachment, affix a load capacity label for the
truck with attachment to the battery cover and affix a
symbol label at the rear of the appropriate control lever.
2
e335-02/129

Operating the sideshift

- Push control lever (2) to the left (this will move the sideshift
to the left).
- Push control lever (2) to the right (this will move the
sideshift to the right).

Operating the clamp

- Push control lever (2) forward (this will open the clamp).
- Pull control lever (2) back (this will close the clamp).
WARNING
Attachments not supplied with the truck may
only be employed if an authorized distributor
ascertains that a safe operation is assured in respect to
load capacity and stability.
e336-02/78
Operation
e336-02/79