Inspection And Maintenance As Required; Check Seat Belt For Condition And Operation - Linde E 20-02 Operating Instructions Manual

Inspection and maintenance as required

Check seat belt for condition and operation

NOTE
For safety reasons the condition and operation of the
retention system should be inspected regularly (month-
ly). Under extreme operating conditions this check is
required daily before taking the truck into operation.
- Pull the belt (2) out fully and inspect for fraying.
- Check the lock (3) for correct operation and the retractor
for proper return of the belt.
- Check covers for damage.
3
2
62
- Check the automatic lock.
- Park the truck on level ground.
- Pull out the belt with a jerk.
The automatic lock should prevent the belt from unroll-
ing from the retractor (1).
- Swing the overhead guard to the first lock-in position.
The automatic lock should prevent the belt from un-
rolling from the retractor (1).
CAUTION
Do not operate the truck with a faulty seat belt.
Have a defective seat belt replaced immediately
by your authorised dealer.
1
e336-02/22
CAUTION
To prevent back injury, the weight setting should
be set to the individual weight of the driver.
To prevent injuries, do not store any objects in the tilting
range of the seat.
To prevent accidents, check that all adjustments are
properly engaged before operating the truck.
Do not operate the seat adjusting devices while operating
the truck.
Seat belts must be applied before operation of the truck.
After an accident, the seat belt must be renewed. In the
case of seat belts attached to the operator seat, the seat
and mounting of the seat must also be inspected by
qualified personnel.
Nuts and bolts should be checked regularly for tightness.
A wobbling of the seat can indicate loose bolts or other
faults. If malfunctions in the operation of the seat are
detected (e.g. seat cushioning), contact your authorised
dealer immediately to eliminate the cause. In case of non-
observance, you put your health in danger and there is a
higher risk of accidents.
1
e336-02/45
Maintenance