Single Control Lever Operation Of Mast And Attachments - Linde E 20-02 Operating Instructions Manual

Single control lever operation of mast and attachments

WARNING
Use the lifting device and attachments only for
authorised applications. The operator must be
instructed in the handling of the lifting device and attach-
ments. Observe the maximum lift height. Do not put your
hands or any other part of the body into the lift mast or the
space between the mast and truck.
Always operate the control lever smoothly; do not jerk.
The speed of lifting, lowering and tilting is determined by how
far the lever is moved.
The lever is designed to return to the neutral position when
released.
NOTE
Note the operating symbols with arrows.
Raising the fork carriage
WARNING
Do not step on the raised forks. Increased danger
of falling and being squeezed.
- Pull the control lever (1) back.
1 2 3
Lowering the fork carriage
- Push the control lever (1) forward.
Tilting the mast forward
- Push the control lever (2) forward.
Tilting the mast back
- Pull the control lever (2) back.
Operating the attachments
Attachments (e.g. sideshift, clamp, etc.) can be fitted on the lift
truck as optional equipment. Observe the operating pressure
and instructions for the attachment.
One or two additional control levers are fitted for its operation.
NOTE
For each attachment, affix a load capacity label for the
truck with attachment and a symbol label for the respective
attachment to the battery cover.
4
e335-02/130
Operating the sideshift
- Push control lever (3) forward (this will move the sideshift
to the left).
- Pull control lever (3) back (this will move the sideshift to
the right).
Operating the clamp
- Push control lever (4) forward (This will open the clamp).
- Pull back on control lever (4) (This will close the clamp).
WARNING
Attachments not supplied with the truck may
only be employed if an authorised distributor
ascertains that a safe operation is assured in respect to
load capacity and stability.
Operation
e336-02/80
37