Wheel Change; Jack Locations: Changing The Rear, Front Wheels - Linde E 20-02 Operating Instructions Manual

Wheel change

Wheel change
CAUTION
Only use a jack with a sufficient load capacity.
Minimum load capacity is 3600 kg.
CAUTION
If for a wheel change not antistatic wheels are
mounted the truck must be fitted with an antistatic
ribbon, because these wheels are not electrically
conductive.
Please contact your authorised Linde dealer.
Jack locations:
Changing the rear wheels
- Loosen the fasteners of the wheel to be changed.
- Remove the tow pin (1) from the tow coupling.
- Pull the lid out of the hole in the counterweight.
- Insert the tow pin (1) fully into the hole.
- Place the jack under the tow pin and raise the truck. Make
sure that the flat end of the tow pin rests on the piston of
the jack.
ATTENTION
The truck may only be raised at this spot at the
rear.
- Secure the lifted truck with suitable blocks of wood.
- Remove the wheel fasteners and change the wheel.
- Install the wheel fasteners and tighten them by hand.
- Lower the truck.
- Tighten all wheel fasteners to a torque of:
e3363416
Changing the front wheels
- Loosen the fasteners of the wheel to be changed.
- Remove the tow pin (1) from the tow coupling.
- Pull the lid out of the hole in the chassis at the front left-
hand or right-hand side.
- Insert the tow pin (1) fully into the hole.
- Place the jack under the tow pin and raise the truck. Make
sure that the flat end of the tow pin rests on the piston of
the jack.
ATTENTION
The truck may only be raised at this spot at the
front.
- Secure the lifted truck with suitable blocks of wood.
- Remove the wheel fasteners and change the wheel.
- Install the wheel fasteners and tighten them by hand.
- Lower the truck.
210 Nm. - Tighten all wheel fasteners to a torque of:
1
336/56
Operation
460 Nm.
1
e336-02/15
51