Truck Data Management (Lfm); Truck Data Acquisition; Condition Code - Linde E 20-02 Operating Instructions Manual

Truck Data Management (LFM)

Truck data acquisition

The input unit (1) for entering vehicle data is located next to
the console.
The terminal has a keypad (3) with 12 keys. With the standard
setting, a 5-digit PIN number assigned to the operator en-
sures that only authorised personnel can operate the truck.
The truck can only be started after this PIN number and
maybe a condition code (depending on the setting) has been
entered.
NOTE
The PIN number can be enlarged from 5 to 8 digits.
Before entry of the PIN number, please request your truck
pool manager to give you the number of digits of the PIN
number and the setting of the truck.
* Option
40
*

Condition code

NOTE
The code indicates the state of the truck.
The following code numbers are available:
0 = Truck in working order
1 = Request Service (truck cannot be started)
2 = Request Maintenance (truck can be started)
3 = Driving problem
4 = Lifting problem
5 = Steering problem
6 = Damaged in accident
7 = User-defined**
8 = User-defined**
9 = User-defined**
** The condition codes 7, 8, 9 can be defined by the user
as he chooses.
Please contact your truck pool manager for the definition
of these condition codes.
NOTE
If you notice one of these conditions (eg driving problem)
only after you have first logged in with condition code 0
(truck in working order), you must first log out (turn the
rotary knob (2) anticlockwise as far as possible) and log
in again with condition code 3 (driving problem).
Operation