Sideshift: Clean, Grease And Check The Mounting; Check The Braking System; Check The Brake Linings, Lubricate The Brake Lever Pivot - Linde E 20-02 Operating Instructions Manual

Inspection and maintenance every 500 to 1000 hours or annually
Sideshift * :
Clean, grease and check the mounting
- Clean the sideshift with a steam jet.
- Inspect the hydraulic pipes and hoses for chafe marks,
and replace any pipes and hoses, if required.
- Check the hydraulic fittings and mounting elements for
security and wear, and tighten or replace them, if required.
- Adjust the forks to gain access to the grease nipples (1).
- Lubricate the fork carriage grease nipples (1) with lubricat-
ing grease until new grease emerges at the side.
NOTE
The sideshift must be greased each time the truck is
cleaned.
* Option
1

Check the braking system

The proper operation of the handbrake (1) and the brake
pedal (2) must always be ensured. If faults due to mechanical
wear become evident (e.g. worn brake linings or scored brake
discs), please contact your authorised distributor.
CAUTION
Do not operate your fork truck if the brakes are
faulty.
e336/106
1
2
e336-02/46
Maintenance
Check the brake linings, lubricate the brake
lever pivot
- Depress the emergency button.
- Open the overhead guard to the 2nd lock-in position.
- Check the surface of the brake linings and brake discs.
- Check the thickness of the brake linings.
- Minimum brake lining thickness
ATTENTION
Should faults or wear in the braking system
become evident, please contact your authorised
distributor.
- Lubricate the pivot grease nipples (3) with a grease gun
until new grease emerges at the pivot.
3
4 mm.
e336-02/49
69