Check The Fork Quick-Releases And Fork Stops; Check The Pre-Tension Of Double Hoses If Attachments Are Fitted; Check The Hydraulic Oil Level - Linde E 20-02 Operating Instructions Manual

Inspection and maintenance every 500 to 1000 hours or annually

Check the fork quick-releases and fork stops

- Examine the forks for visible deformation and damage.
- Check the bolts of the fork quick-releases (2, 3) and fork
stops (1) for proper seating and damage.
- Renew any defective parts.
1
3
72
Check the pre-tension of double hoses if
attachments are fitted
- The pre-tension of the double hoses should be 5 to 10 mm
per meter referred to initial length.
- Adjust the pre-tension to the specified value by shifting the
hoses in the clamps.
2
336/85

Check the hydraulic oil level

ATTENTION
Follow the precautions for handling fluids and
lubricants.
ATTENTION
Check the hydraulic oil level only with the mast
vertical and the fork carriage lowered.
- Apply the handbrake.
- Depress the emergency stop button.
- Tilt the overhead guard past the first lock-in position and
release it.
- Pull out the breather filter (1) and oil dipstick (2).
- Wipe the oil dipstick with a clean cloth.
- Fully re-insert the breather filter and dipstick and pull it out
again.
- The oil level should be between the marks on the dipstick.
- If needed, top up the hydraulic oil as far as the top mark.
- Refit the breather filter.
1
336/88
Maintenance
1
2
e336-02/51