Truck Data Acquisition - Default Setting (Pin Number And Condition Code) - Linde E 20-02 Operating Instructions Manual

Truck Data Management (LFM)
Truck data acquisition - default setting (PIN
number and condition code)
Logging in and starting the truck:
- Engage the parking brake.
- Press any key to take the terminal into operation.
The green LED (2) flashes.
- Enter your PIN number and condition code (factory
setting = 0 0 0 0 0).
On a truck in proper working order as the following PIN
No.: 00000 0.
NOTE
In case the incorrect PIN number was entered, it can be
corrected after pressing the key (4) with the asterisk.
- Confirm the entry by pressing the #-key (3).
The green LED (2) is on steadily.
* Option
*
NOTE
If the red LED (1) comes on, an incorrect PIN number was
entered. Press the key (4) with the asterisk and enter the
correct number. After more than three incorrect inputs
(factory setting), the red LED (1) is on steadily and the
green LED (2) flashes. A valid PIN input is disabled for 10
minutes. The disable period can be terminated by entering
a special PIN number. Please contact your pool manager.
- Turn the rotary knob (5) clockwise as far as possible and
start the truck.
NOTE
If the truck does not start properly at the first attempt, the
starting procedure can be repeated until the rotary knob
(5) is returned to zero and the PIN number is deleted from
memory after the expiration of the delay period.
NOTE
If the green (2) and red (1) LEDs are both illuminated
steadily, the data must be read out. Please inform your
pool manager at once.
Turning the truck off and logging out:
- Turn the rotary knob (5) anticlockwise as far as possible to
turn off the engine.
- After an delay period (factory setting = 10 seconds), the
red LED (1) comes on briefly and then the green (2) and
red (1) LEDs flash about 3 seconds. During this time the
truck can be started any time. The LEDs then go out and
the PIN number is no longer stored.
NOTE
The delay time can be set between 10 seconds and 10
minutes with the FDE configuration software. Please
contact your Linde dealer in this regard.
NOTE
Pressing the key (3) with the #-symbol after the engine is
turned off terminates the delay period at once and the PIN
number is deleted from memory.
Operation
41