Lubricate The Mast And Tilt Cylinder Pivots; Retighten The Mast Fastening Bolts - Linde E 20-02 Operating Instructions Manual

Inspection and maintenance every 500 to 1000 hours or annually

Lubricate the mast and tilt cylinder pivots

NOTE
Use a lubricating grease.
- Raise the fork carriage and secure it against inadvertent
lowering with a chain.
- Lubricate the left and right mast pivot grease nipples (1).
- Lubricate with a grease gun until some fresh grease
emerges at the pivots.
- Remove the securing chain and fully lower the fork carriage.
1
68
- Open the overhead guard to the 1st lock-in position.
- Lubricate the left and right grease nipples (2) of the tilt
cylinder at the mast and chassis with grease.
- Lubricate with a grease gun until new grease emerges at
the pivots.
- Close the overhead guard.
2
336/78

Retighten the mast fastening bolts

- Elevate the fork carriage and secure against inadvertent
lowering.
- Check the fastening bolts (3) (2 on each side) of the mast
pivot bearing shells for tightness.
Torque: ................................................................ 275 Nm
3
e336-02/77
Maintenance
e336-02/73