Renew The Carbon Brushes; Tighten The Wheel Nuts; Check The Tyres For Damage And Foreign Objects - Linde E 20-02 Operating Instructions Manual

Inspection and maintenance as required

Renew the carbon brushes

ATTENTION
For the service life of the motors it is important
to renew the carbon brushes in time.
When the carbon brushes must be changed, the warning light
(1) in the composite instrument will go on.
- Elevate the fork carriage and secure it against inadvertent
lowering.
- Open the overhead guard to the 2nd lock-in position.
- Lift up the rubber cover on the traction motors.
- Remove the cover bands on the traction motors (2, 5) and
the hydraulic pump motor (6).
- Relieve the tension of the carbon brush springs (3).
- Withdraw the brushes (4) from their guides.
- Replace the brushes.
1
!
P
5
4
64
- Pretension the springs and check the brush connections
for firm seating.
NOTE
Renew the brushes only in sets.
- Fit the cover bands.
2
3
336/67

Tighten the wheel nuts

ATTENTION
(Every 100 hours minimum)
- Check all wheel collar nuts for the proper torque:
front wheel collar nuts ......................................... 460 Nm
rear wheel collar nuts ......................................... 210 Nm
Check the tyres for damage and foreign
objects
- Secure the truck against rolling (apply the parking brake).
- Chock a wheel that is not to be raised.
- Jack up the truck until the wheels are clear of the ground.
- Secure the truck with wooden blocks.
- Check the wheels for ease of movement and remove
anything hindering their movement.
- Renew worn or damaged tyres.
6
e336-02/26
Maintenance
e336-02/21