Viconics VTR8300 Series User Interface Manual page 73

Wireless IO Settings
The Wireless IO settings screen allows the discovery of and pairing with a Smart Controller.
Note: ZigBee module required
PARAMETER DETAILS
Configuration Parameters Default Value
Network status
Read Only
Permit join
Default value: Off
Permit timeout
Default value: 0
Read Only
Viconics Technologies Inc. | 7262 Marconi
028-6045-06
Wire le s s IO S ettin gs
N e t wo rk st a t u s
P er mi t jo in
P er m it ti me o u t
Id en t if y q u e ry
I npu t so u rc e
P ai red d e v ic e s
ZigBee Network Status
Shows the current status of the ZigBee network.
Not det: ZigBee communication module not detected
Pwr on: ZigBee communication detected but not configured
No NWK: ZigBee configured but no network joined
Joined: ZigBee network joined
Online: Communicating (Exchanging data)
Display Readings: Not det., Pwr on, No NWK, Joined and Online
Permit join
On: Activates search mode
Off: Changing value to "Off" locks out any new ZigBee devices from joining the
network through this Room Controller.
Choices: On or Off
Permit Join Timeout
Allows devices to join the Coordinator Room Controller for 180 minutes from the
moment it is set to ON. The Room Controller stops searching when the 180 minutes
expires.
NOTE: Permit Join parameter must be set to 'On' to enable this feature.
Display Time: 0 or 180 minutes
| Montreal, Quebec, Canada | H2R 2Z5
N ot d et.
Off
0 m in
Off
0
0
Significance and Adjustments
| Tel: (514) 321-5660 | Fax: (514) 321-4150 | www.viconics.com | sales@viconics.com
November 2017
73