Viconics VTR8300 Series User Interface Manual page 20

20
ZIGBEE NETWORK 1/2
The ZigBee Pro Network screen shows only when the optional ZigBee Pro communication module is detected in the device. When
setting up a ZigBee network to bind with multiple devices, there must first be a Coordinator to manage the initial binding between the
Router and the end devices. After successful binding, the Router becomes the parent to the end devices.
NOTE: Before binding any ZigBee devices, the network must first be created by the Coordinator.
PARAMETER DETAILS
Configuration Parameters Default Value
COM address
Default value: 254
Node type
Default: Router
Pan ID
Default value: 0
Viconics Technologies Inc. | 7262 Marconi
028-6045-06
1/2 ZigBee Network
COM address
Node type
PAN ID
Channel
Network status
Permit join
COM Address
Room Controller networking address. For wireless models, the use of the COM
address is not mandatory. The COM address is an optional way to identify a device
on the network and is recommended if used with an MPM. It is Mandatory for BACnet.
Range: 0 to 254
Node Type
Sets device to act as Router or Coordinator in a network.
Coordinator: Creates the network and manages the binding of wireless devices.
Router: Joins a network created by a coordinator (permit join must be set to 'ON').
Choices: Coordinator or Router
ZigBee Pan ID
Personal Area Network Identification that links specific Room Controllers to specific
ZigBee coordinators. For every Room Controller reporting to a coordinator, set the
SAME PAN ID value both on the coordinator and the Room Controller.
NOTE: The default value of 0 is NOT a valid PAN ID.
NOTE: For Room Controllers running Firmware version 1.3 and earlier, the PAN ID
must be set to 501-1000 for the Room Controller to act as a coordinator.
Range: 1 to 32767
| Montreal, Quebec, Canada | H2R 2Z5
254
Router
25
15
No NWK
Off
Significance and Adjustments
| Tel: (514) 321-5660 | Fax: (514) 321-4150 | www.viconics.com | sales@viconics.com
November 2017