VTR8300 Series Installation Guide Room Controller with Optional PIR sensor Commercial and Hotel/Lodging HVAC Fan Coil Applications CONTENTS Installation Location Installation Terminal, Identification and Function Communication wiring to VC3xxxX Relay Pack BACnet Communication Wiring (if applicable) ® Network wiring topology...
Page 2
Controller. A short circuit or wrong wiring may permanently damage the Terminal Equipment Controller or the equipment. • All VTR8300 series controls are designed for use as operating controls only and are not safety devices. These instruments have undergone rigorous tests and verification prior to shipping to ensure proper and reliable operation in the field. Whenever a control failure could lead to personal injury and/or loss of property, it becomes the responsibility of the user / installer / electrical system designer to incorporate safety devices (such as relays, flow switch, thermal protections, etc…) and/or an alarm system to protect the...
• A short circuit or wrong wiring may permanently damage the Terminal Equipment Controller or the equipment. • All VTR8300 series controls are designed for use as operating controls only and are not safety devices. These instruments have undergone rigorous tests and verification prior to shipping to ensure proper and reliable operation in the field.
Installation Guide VTR8300 Series TERMINAL, IDENTIFICATION AND FUNCTION Only ONE VC3xxxX Relay Pack with remote All VTR83xxA Terminal Identification monitoring inputs can be used under a single Terminal Equipment Controller VTR83xxA Controller. All other slave units must be Terminal 4 Tx –...
Installation Guide VTR8300 Series HOW TO ENTER SETUP SCREEN Touch and hold this point for 3 seconds to enter setup mode Note: If a configuration / installer password is activated to prevent unauthorised access to the configuration menu parameters, a...
Installation Guide VTR8300 Series Specifications Terminal Equipment Controller power requirements 7.0 VDC +/- 10% 2.4 watts minimum 0 °C to 50 °C ( 32 °F to 122 °F ) Operating conditions 0% to 95% R.H. non-condensing -30 °C to 50 °C ( -22 °F to 122 °F ) Storage conditions 0% to 95% R.H.