Masks - Sony CCP-8000 Series User Manual

Key Edge Pattern: Use a color mixing pattern for key edge.
You can change this pattern by pressing [Pattern Select] to open the menu
for edge color mix dedicated wipe pattern selection (Mix Pattern Select
menu), and make adjustments by pressing [Pattern Adjust] to open the
menu for pattern adjustment (Matte Adjust menu).
Mask Pattern: Use the main mask Box or Pattern.
You can also press [Pattern Select], and in the corresponding pattern
adjustment menu, change the pattern.
5
To adjust the color, press [Zabton Color] and adjust the following
parameters.
Knob
1
2
3
4

Masks

There are two masks, which can be used to mask off unneeded parts of a key
or background, or to remove defects, and these are known as the main mask and
subsidiary mask.
You can either use the main mask and subsidiary mask independently, or at the
same time.
Using the main mask
For example, to use the main mask for key 1 on the M/E-1 bank, use the
following procedure.
1
In the M/E-1 >Key1 menu, select HF3 'Main Mask.'
The Main Mask menu appears.
2
In the <Mask Type> group, select the mask type.
Key Mask: Masks a part of a key.
Bkgd Mask: Masks a part of a background.
3
In the <Mask Source> group, select the mask source.
Box: signal from the dedicated box generator
Pattern: signal from the dedicated pattern generator
Parameter Adjustment
Luminance Luminance
Saturation Saturation
Hue Hue
Density Density
Setting values
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00
0.00 to 100.00
Key Setting Operations Using Menus
225