Dme Wipe Snapshots; Dme Wipe Snapshot Operations With The Flexi Pad - Sony CCP-8000 Series User Manual

DME Wipe Snapshots

You can snapshot and save a DME wipe pattern together with the current
settings of its modifiers and pattern limit in a dedicated register for recall when
required.
There are 10 DME wipe snapshot registers for each of the M/E and P/P banks.
To save and recall these registers, use the Flexi Pad control block, the
Multifunction Flexi Pad block in each switcher bank or the Menu control
block.
In the case of a simple transition system, there are eight DME wipe snapshot
registers for each switcher bank.

DME Wipe Snapshot Operations With the Flexi Pad

To carry out DME wipe snapshot operations, use the Flexi Pad control block.
You can save, recall and delete DME wipe snapshots using the procedures
similar to the procedures for wipe snapshot operations. In DME wipe snapshot
operations, use the [DME] button instead of the [WIPE] button used in wipe
snapshot operations.
Selecting a DME wipe pattern in the Flexi Pad control block
In the standard type Flexi Pad control block, enter a four-digit pattern number,
using the [DME] button.
For details, see "Flexi Pad Control Block (Standard Type)" (page 55).
Notes
• You cannot select a DME wipe pattern in the simple type Flexi Pad control
block.
• A button in the memory recall section in which a DME wipe snapshot is
saved shows the pattern, and lights yellow.
For a user-programmable DME, the register number (see page 353) appears.
Depending on the setting of the Setup menu (see "Operation Settings
(Operation Menu)" in Chapter 19 (Volume 3)), you can also display a
register name.
• In a simple type Flexi Pad control block, it is not possible to delete a DME
wipe snapshot.
For details of the operating procedures, see "Wipe Snapshots" (page 308).
351
DME Wipe Snapshots