Sony CCP-8000 Series User Manual page 174

Buttons lit
In the bus fixed mode there is a fixed relationship between the position of the
fader lever and the signal output on each bus. Depending on the direction of the
transition, the fader lever must therefore always be moved in a particular
direction, as shown in the following table. This does not affect an auto
transition, which is executed regardless of the fader lever direction.
Fader lever operating direction in bus fixed mode
Next transition Transition direction
Background A t B
B t A
Keys 1, 2, 3, and 4 On t Off (deletion)
Off t On (insertion)
• When a transition applies to a combination of more than one of the
background and keys 1, 2, 3, and 4, then the transition for all of these must
be in the same direction complying with the above table.
• If as a result of an auto transition, for example, the fader lever position does
not agree with the signal output, this is a non-sync state (see page 171) and
LEDs light at both end positions of the fader lever travel. Moving the fader
lever does not carry out a transition, but when the fader lever reaches the end
position the non-sync state is released, and it is now possible to carry out the
next transition. If the fader lever is moved in the direction away from the lit
LEDs, this carries out the next transition, over the remaining part of the fader
lever travel.
Fader
lever
Flip-flop mode and bus fixed mode
Flip-flop mode
Bus fixed mode
Fader lever movement
Downward
Upward
Downward
Upward
Executing a Transition
173