Sony CCP-8000 Series User Manual page 245

Using two or three DME channels on one keyer
When using the DME dedicated interface, proceed as follows.
1
2
3
Using four DME channels on one keyer
When using the DME dedicated interface, proceed as follows.
1
2
3
244
Key Setting Operations With the Key Control Block
The later selection is valid, and the button lights green.
Select the DME for the first channel (see the previous item, "Assigning a
DME to a key"), then select the successive channel for the second channel.
For the third channel select the channel after that.
To select the video signal for the second channel, hold down the [UTIL]
button in the cross-point control block, and select the signal in the Key1
row (DME external video bus).
To select the video signal for the third channel, hold down the [UTIL]
button in the cross-point control block, and carry out the following
operation.
• If the selected DME is channel 3 or channel 4, turn off the [KEY4]
button in the key 2 row, then select the signal in the key 2 row (DME
utility 1 bus).
• If the selected DME is channel 7 or channel 8, turn on the [KEY4] button
in the key 2 row, then select the signal in the key 4 row (DME utility 2
bus).
Select the DME channel 1 (or channel 5) for the first channel (see
"Assigning a DME to a key" (page 243)). In the same way, select the DME
channel 2 (channel 6) for the second channel, the DME channel 3 (channel
7) for the third channel, and the DME channel 4 (channel 8) for the fourth
channel.
To select the video signal for the second channel, hold down the [UTIL]
button in the cross-point control block, and select the signal in the Key1
row (DME external video bus).
To select the video signal for the third channel, hold down the [UTIL]
button in the cross-point control block, and carry out the following
operation.
• If the selected DME is channel 3, turn off the [KEY4] button in the key
2 row, then select the signal in the key 2 row (DME utility 1 bus).
• If the selected DME is channel 7, turn on the [KEY4] button in the key
2 row, then select the signal in the key 4 row (DME utility 2 bus).