Sony CCP-8000 Series User Manual page 169

3
Executing a pattern limit transition
1
2
3
To cancel the pattern limit
To cancel the pattern limit after completion of step 3 in the previous procedure,
press the [PTN LIMIT] button, turning it off.
If after carrying out step 2 in the previous procedure, the pattern limit has been
reached, carry out the following procedure.
1
2
168
Executing a Transition
Turn the knobs to adjust the following parameters.
Knob Parameter
1 Pattern Limit
a) 0.00%: Executing the transition does not change the video output at all.
b) 100.00%: The transition is the same as when no pattern limit is set, but the cross-point
button selections of the background A and B buses do not interchange when the transition
completes.
Press the [PTN LIMIT] button, turning it on.
The button you pressed lights amber.
Carry out the transition.
The transition progresses as far as the set pattern limit. Even if the
transition completes, the cross-point button assignments of the background
A and B buses do not interchange.
Carry out the transition once again.
The status before the previous transition is restored.
Press the [PTN LIMIT] button.
The button you pressed lights green.
Carry out the transition.
The [PTN LIMIT] button goes off, and the pattern limit state is released.
Depending on the way in which the transition was executed, the action will
be as follows.
• When you press the [CUT] button, the pattern limit is immediately
released, and the image switches instantaneously.
• When you press the [AUTO TRANS] button, until the state of the next
transition, the transition is carried out over the duration given by the
transition rate.
• When you move the fader lever, the transition is carried out from the
pattern limit state to the state before the pattern limit transition was
Adjustment Setting values
Pattern limit
0.00
a) b)
to 100.00%