Ethernet Packet Generator Control 1; Table 3.34 Epg Control Register 1, Address 29E1 (0X1D) - Renesas R-IN32M4-CL2 User Manual

Gigabit ethernet phy edition
Hide thumbs Also See for R-IN32M4-CL2:
Table of Contents

Advertisement

R-IN32M4-CL2 User's Manual Gigabit Ethernet PHY Edition
3.3.4

Ethernet Packet Generator Control 1

The EPG control register provides access to and control of various aspects of the EPG testing feature. There are two
separate EPG control registers. The following table shows the settings available in the first register.

Table 3.34 EPG Control Register 1, Address 29E1 (0x1D)

Bit
Name
15
EPG enable
14
EPG run or stop
13
Transmission duration
12:11
Packet length
10
Interpacket gap
9:6
Destination address
5:2
Source address
1
Payload type
0
Bad frame check sequence
(FCS) generation
The following information applies to the EPG control number 1:
• Do not run the EPG when the GbE-PHY is connected to a live network.
• bit 29E1.13 (continuous EPG mode control): When enabled, this mode causes the device to send continuous packets.
When disabled, the device continues to send packets only until it reaches the next 10,000-packet increment mark. It
then ceases to send packets.
• The 6-byte destination address in bits 9:6 is assigned one of 16 addresses in the range of 0xFF FF FF FF FF F0
through 0xFF FF FF FF FF FF.
• The 6-byte source address in bits 5:2 is assigned one of 16 addresses in the range of 0xFF FF FF FF FF F0 through
0xFF FF FF FF FF FF.
• If any of bits 13:0 are changed while the EPG is running (bit 14 is set to 1), bit 14 must be cleared and then set back
to 1 for the change to take effect and to restart the EPG.
R18UZ0043EJ0100
Mar 4, 2016
Access
R/W
1: Enable EPG
R/W
1: Run EPG
R/W
1: Continuous (sends in 10,000-packet increments)
0: Send 30,000,000 packets and stop
R/W
00: 125 bytes
01: 64 bytes
10: 1518 bytes
11: 10,000 bytes (jumbo packet)
R/W
1: 8,192 ns
0: 96 ns
R/W
Lowest nibble of the 6-byte destination address
R/W
Lowest nibble of the 6-byte source address
R/W
1: Randomly generated payload pattern
0: Fixed based on payload pattern
R/W
1: Generate packets with bad FCS
0: Generate packets with good FCS
Description
3. Registers
Default
0
0
0
00
0
0001
0000
0
0
Page 34 of 39

Advertisement

Table of Contents
loading

This manual is also suitable for:

R9j03g019gbg

Table of Contents