Protective Covers; Pump Exhaust; Spacing - Gilson VERITY 1910 MS User Manual

Safety Precautions
The following safety precautions concerning the operation of the VERITY 1910 MS Detector
and the site in which it is used must be observed at all times in order to prevent injury and
damage to the system and associated instruments.
WARNING
WARNING
WARNING

Protective Covers

Unless specifically instructed, do not remove any protective covers. The product is sealed
at the factory. Damage or removal of the warranty seals leads to the loss of liability and
warranty entitlements.

Pump Exhaust

The pump exhaust from the VERITY 1910 MS Detector must be connected to a suitable
extraction system. Appropriate extraction must also be provided to the microspray area when
analyzing hazardous chemicals.

Spacing

Allow sufficient spacing around the VERITY 1910 MS Detector for proper cooling and for the
connection of mains plug, gas inlets, syringe pump, HPLc etc.
8 |
SAFETY VERITY® 1910 MS DETEcToR
Do not use the instrument if there are signs of visible damage.
Do not operate if site conditions are not within specifications.
Do not override any safety interlock.
Do not attempt to operate the instrument with the covers removed. High voltages are present
when the instrument is in operation.
Do not attempt to adjust or replace components other than those that have been described in
this user's guide.
The instrument is not designed to be operated in a potentially explosive atmosphere. It is the
responsibility of the customer to verify the operating environment meets the requirements of
a "non-hazardous area" with regards to potentially explosive atmosphere.
At least two people are required to lift or move the VERITY 1910 MS Detector.
The VERITY 1910 MS Detector should only be used with accessories that meet the
manufacturer's specifications. Failure to do so may result in damage to the instrument and
lead to the loss of liability and warranty entitlements.
To prevent injury and damage to equipment, ensure the blanking plug is removed from the
exhaust port before activating the pumps.