Gilson VERITY 1910 MS User Manual page 49

Cleaning Guidelines
The items used with the VERITY 1910 MS Detector that can be maintained by the user are the
spraychip®, vac-chip™ and split flow interface (SFI). All items can be cleaned and/or replaced
by the user.
The following warning notices apply to all cleaning procedures detailed in this chapter.
Handling toxic, flammable and hazardous chemicals can lead to health and safety risks.
Local safety regulations must be followed and suitable PPE must be worn.
The chemicals should only be handled in accordance with manufacturers
MSDS (Material Safety Data Sheet).
WARNING
Appropriate safety measures should be observed when using the ultra‑sonic bath (please
WARNING
refer to the manufacturer's notes).
Always wear powder‑free gloves when handling all components of the vac‑chip assembly.
NOTICE
Fingerprints can cause problems with the operation of these devices.
System Flush
It is recommended to flush the system daily with methanol and water for ten minutes to
remove the sample from the microfluidic lines and minimize system carryover.
VERITY® 1910 MS DETEcToR
49
| USER'S GUIDE