R&S TSMA6 Series User Manual page 61

®
R&S TSMA6
11. About one minute after the operating system is up again, the flash of the main-
board firmware starts.
The microcontroller flash is indicated like following:
Meas LED = red, mode LED = off
Fans are switched to full speed.
Note: Step
age contains a new mainboard firmware.
12. After the reboot, call the web GUI. After a while, the status text in the web GUI
changes to No error.
The LED changes like following:
Mode LED = green resp. blue (depends on the state of the WLAN access point)
13. The "Overview" page in the web GUI needs to display the installed firmware/soft-
ware version.
User Manual 4900.8057.02 ─ 06
step 11 is only performed during firmware update, if the firmware pack-
Update and Restore
Firmware Update
61