Master Image - R&S TSMA6 Series User Manual

®
R&S TSMA6
1. Connect mouse, keyboard and monitor to the R&S TSMA6.
2. Press the [Shift] key and reboot the operating system.
3. The R&S TSMA6 reboots in the R&S recovery environment.
4. Select "Factory Default Restore".
5. Select "Start Recovery".
The R&S TSMA6 recovery starts and the "Mode" LED blinks green.
NOTE: Do not interrupt the recovery process.
6. When the recovery has finished, press Exit/Reboot.
7. After the reboot, check if a microcontroller flash is performed (LED blue/green).

7.5 Master Image

The process of creating a master image of a R&S TSMA6 device and deploying this
master image to other R&S TSMA6 devices is split into the following main steps.
●
Prepare a TSMA6 Image Stick and a TSMA6 Recovery Stick (see
"Prepare a TSMA6 Image Stick / TSMA6 Recovery
●
Install the RSRecoveryCreator tool on a PC (see
RSRecoveryCreator Tool
●
Capture a TSMA6 Image of the master device using the TSMA6 Image Stick (see
Chapter 7.5.3, "Capture a TSMA6 Image (TSMA6 Image
●
Create a TSMA6 Recovery Stick from a captured TSMA6 Image using the
RSRecoveryCreator tool (see
on page 89).
●
Recover the master image on a different R&S TSMA6 device using the TSMA6
Recovery Stick (see
Recovery
User Manual 4900.8057.02 ─ 06
", on page 85).
Chapter 7.5.5, "Deploy a TSMA6 image from a TSMA6
Stick", on page 91).
Stick",
Chapter 7.5.2, "Install the
Chapter 7.5.4, "Create a TSMA6 Recovery
Update and Restore
Master Image
Chapter 7.5.1,
on page 82).
Stick)", on page 86).
Stick",
81