Connecting External Devices - R&S TSMA6 Series User Manual

®
R&S TSMA6
Risk of instrument damage due to inappropriate operating conditions
Specific operating conditions are required to ensure accurate measurements and to
avoid damage to the instrument. Observe the information on appropriate operating
conditions provided in the basic safety instructions and the instrument's data sheet.
Check the equipment for completeness using the delivery note and the accessory lists
for the various items. Check the instrument for any damage. If there is damage, imme-
diately contact the carrier who delivered the instrument. Make sure not to discard the
box and packing material.
Packing material
Retain the original packing material. If the instrument needs to be transported or ship-
ped later, you can use the material to protect the control elements and connectors.
Accessories
The following items are included with shipment of the R&S TSMA6:
●
12 V DC power supply cable with a cigarette lighter connector
●
Wide range RF paddle antenna (700 MHz to 2600 MHz)
●
Active GPS patch antenna
●
LAN cable with ferrit
●
Ferrit for LAN cable supplied by the customer
Optional Accessories
The following items are optionally available.
●
TSMA6-ZCB2 (Carrying Bag)
●
TSMA6-Z1 (AC Adapter)
●
TSMA6-Z2 (19" Rack Adapter)
●
TSMA6-Z5 (Carrying Box)

5.2 Connecting External Devices

The following external devices must be connected before connecting the power supply.
The SMA connector is sensitive to mechanical stress. Use the following handling pre-
cautions.
●
Always use a torque wrench and mount the cable end with 60 Ncm.
●
Do not stack adapters directly at the SMA connector. If you need to use adapters
(e.g: SMA to N), then always use a specific adapter cable (R&S no. 4900.1700.00).
User Manual 4900.8057.02 ─ 06
Preparing for Use
Connecting External Devices
20