Basic Setup Procedure; Figure 2.9 Xfr Gpib Cable With Ferrite Block - Xantrex GPIB-M-HPD Operating Manual

Basic Setup Procedure

This procedure can be used as a quick reference for those familiar with the
configuration requirements for the GPIB-M interface as installed in the DC power
supply.
IEEE-488 Controller Connection
Connect the GPIB cable to the supply at connector on the rear panel. Use an
approved IEEE-488 connector and cable when connecting the GPIB Interface to
your IEEE-488 GPIB network. Refer to
Figure
Add a ferrite block to reduce radiated emissions. The one inch square ferrite block
with built-in housing clip is packaged and shipped with the power supply interface
card.
To install the ferrite block:
1. Position the block no more than 5 cm (2 in.) from the power supply end of the
2. Open the ferrite block housing.
3. Run the cable through the ferrite block. See
4. Close the housing clip.
The ferrite block ensures that the power supply system meets radiated emission
requirements for CE mark.

Figure 2.9 XFR GPIB Cable with Ferrite Block

Release 2.1
2.7.
user cable.
Ferrite Block" on page
To power supply
GPIB connector
Figure 2.4,
Figure 2.9, "XFR GPIB Cable with
31.
Ferrite Block
Installation and Configuration
Basic Setup Procedure
Figure 2.5, Figure 2.6
GPIB Cable
To personal computer GPIB
connector
or
31