User Lines Connection (Xt, Hpd, Xpd); Figure 2.11 User Signals Connector (Xt, Hpd And Xpd); Figure 2.12 Xt, Hpd, Xpd User Cable With Ferrite Block - Xantrex GPIB-M-HPD Operating Manual

User Lines
Connection
(XT, HPD,
XPD)

Figure 2.11 User Signals Connector (XT, HPD and XPD)

Use a standard 8-connector RJ45 connector and data cable to connect to the user
lines.
Add a ferrite block to reduce radiated emission. The one inch square ferrite block
with built-in housing clip is packaged and shipped with the power supply interface
card.
To install the ferrite block:
1. Position the block no more than 5 cm (2 in.) from the power supply end of the
2. Open the ferrite block housing.
3. Loop the cable through the ferrite block. See
4. Close the housing clip.
The ferrite block ensures that the power supply system meets radiated emission
requirements for CE mark.
Figure 2.12XT, HPD, XPD User Cable with Ferrite Block
Release 2.1
user cable.
Cable with Ferrite Block" on page
To J7 Connector
Figure 2.12, "XT, HPD, XPD User
41.
Ferrite Block
Installation and Configuration
J7 User Cable
To User Custom Interface
User Lines
41