Power On Service Request; Table 2.1 Remote Mode Power On Conditions - Xantrex GPIB-M-HPD Operating Manual

Table 2.1 Remote Mode Power On Conditions

Feature
Voltage setpoint
Current setpoint
Triggered voltage setpoint
Triggered current setpoint
Trigger source
Low voltage setpoint limit
High voltage setpoint limit
Low current setpoint limit
High current setpoint limit
Over voltage protection
Under voltage protection
Over current protection
Under current protection
Fold shutdown protection
AC OFF shutdown recovery
OTP shutdown recovery
Aux line configuration
Power On The Power On Service Request setting causes the power supply to send a service
request to the computer controller when the power supply is turned on or when it
Service
re-initializes after a momentary power interrupt if the following conditions are also
Request
met:
•
•
When a service request is sent, the front panel SRQ LED will also turn on. You can
clear the service request and turn off the SRQ LED by performing a serial poll. See
also
Release 2.1
CAUTION
!
Ensure the power supply chassis is properly connected to ground. The interface
connection system is not capable of handling the resulting excessive ground currents
that may flow through the connection to the controlling computer if the chassis is not
at ground potential.
*PSC (power on status clear) is set to 0, and
bit 5 in the Service Request Enable register has been set (*ESE) prior to power
off.
"Status Byte" on page 79
Factory Preset Value
0.0V
0.0A
Disabled (DEFault)
Disabled (DEFault)
None
0.0V
103% of voltage rating
0.0A
103% of current rating
Disabled (0.0V)
Disabled (0.0V) and not shutdown when tripped
Disabled (0.0A) and not shutdown when tripped
Disabled (0.0A) and not shutdown when tripped
None and delay 0.5s
Auto recover
Latched
None and active low
for information about the SRQ command.
Installation and Configuration
Basic Setup Procedure
33