Section 2. Installation And Configuration; Introduction; Initial Inspection - Xantrex GPIB-M-HPD Operating Manual

Section 2. Installation and Configuration

Introduction

To use this product, you must have the following equipment:
•
•
•
•
•
The GPIB
Your local distributor or service center can also install the interface, especially for
use in a previously-purchased supply already on site. The interface card will be
calibrated and configured with default settings. You will need to configure the supply
for your system using the
Figure 2.1, pg.
panels. The interface subplate is different for each product. Please check
to

Initial Inspection

On first receiving your unit, perform a quick inspection.
•
•
•
If the unit is damaged, save all packing materials and notify the carrier immediately.
For additional information, please see the section titled, "Returning Power Supplies
to the Manufacturer" in the manual shipped with your complete unit.
Release 2.1
a compatible model of DC output power supply
IEEE-488 connector and cable
computer with an IEEE-488 interface card
Computer-based communications software package
parallel CANbus cables (to connect power supply for multichannel operation)
or CANbus
26, Figure 2.2, pg. 27
Figure 2.7.
CAUTION
!
If you remove the unit's cover, use proper static control techniques to avoid damage
to static-sensitive components on the printed circuit board.
Ensure each package contains a power supply with its GPIB interface board
installed, and manuals for the power supply and the GPIB interface. A custom
CANbus cable and a terminator are also supplied with each GPIB-M or
CAN-only interface. Any additional parts shipped with the power supply will be
identified in the supply's documentation.
Inspect the unit for any signs of physical damage such as scratches, cracks, or
broken switches, connectors, or displays.
Check the printed circuit board and components if you suspect internal damage.
interface is usually installed in a power supply at the factory.
"Basic Setup Procedure" on page
and Figure 2.3, pg. 27
31. Refer also to
for drawings of the front
Figure 2.4
25