Section 2. Installation; Overview; Basic Setup Procedure - Xantrex XPR 10-600 Operating Manual

Section 2. Installation

Overview

Section 2
testing the power supply. For more information about controls and connectors, refer
to the front panel diagram
in

Basic Setup Procedure

Table 2.1
subsections in this chapter. Use this table as a quick reference if you are familiar with
the installation requirements for the power supply. If you require more information,
each step in the table refers to a subsequent section which contains more details.
Complete each step in the sequence given.
Table 2.1 Basic Setup Procedure
Step # Description
1 Inspection
2 Installation
3 Input Power
4 Test
5 Select Wires
6 Connect Load
7 Connect Remote
Sensing (if required)
Release 1.1
provides recommendations and procedures for inspecting, installing, and
Section 1.
provides a summary of the setup procedure and an overview of the
Action
Visually inspect the power supply.
Install the power supply, ensuring
adequate ventilation.
Connect AC input power.
Perform functional tests for voltage
mode operation, current mode
operation, and front panel controls.
Select wires that can tolerate the DC
current output.
Connect the load wires to the DC output.
Connect remote sensing connectors on
power supply to load.
(Figure 1.1) as well as the rear panel diagram (Figure
Reference
"Inspection, Cleaning, and
Packaging" on page 26
"Location, Mounting, and
Ventilation" on page 29
"AC Input Power" on page 32
"Basic Tests" on page 35
"Load Wiring" on page 39
"Load Connections" on page 41
"Remote Sensing" on page 45
1.3)
25