Table of Contents
Advertisement
FusionModule1000A40 Prefabricated All-in-One Data
Center
Installation Guide
Use an insulated torque wrench during battery installation. The terminal torque depends on
battery specifications.
M6: 4–6 N· m
M8: 13–15 N· m
M10: 15–20 N· m
Figure 8-18 Connecting battery cables
(1) Bolt
(4) OT terminal
Install a battery bolt in the following sequence: bolt > spring washer > flat washer > OT terminal >
battery connecting piece.
Step 2 Strip the adhesive tape from the iBAT fastener. Attach the iBAT and press it for more than
10s.
Figure 8-19 Securing an iBAT
Issue 03 (2020-06-09)
(2) Spring washer
(5) Battery connecting piece
Copyright © Huawei Technologies Co., Ltd.
8 Installing Devices Inside Pre-fab. Modules
(3) Flat washer
65
Advertisement
Table of Contents
