Huawei FusionModule1000A Installation Manual page 45

Prefabricated all-in-one data center

Hide thumbs Also See for FusionModule1000A:

Table of Contents

FusionModule1000A40 Prefabricated All-in-One Data

Center

Installation Guide

Figure 5-6 Assembling a step ladder

Step 2 Place the step ladder in the middle outside the outward opening door of the pre-fab. module,

and mark mounting holes on the concrete pad for the step ladder.

Step 3 Drill mounting holes using a hammer drill.



Step 4 Rotate nuts onto expansion sleeves to prevent the expansion sleeves from fluttering.

Step 5 Knock the expansion bolts vertically into mounting holes until the flat washers are flush with

the floor.

Step 6 Remove the nuts, spring washers, and flat washers.

Figure 5-7 Installing an expansion bolt (unit: mm)

(A) Nut

Issue 03 (2020-06-09)

When you drill a hole using a hammer drill, keep the drill bit perpendicular to the ground and hold

the drill stock firmly with both hands to prevent irregular drilling and damage to the ground.

If the ground is too hard and smooth for the drill bit to fix its position, use a chisel to punch a pit

before drilling.

5 Installing External Accessories for Pre-fab. Modules

(B) Nut

Table of Contents