Huawei FusionModule1000A Installation Manual page 61

Prefabricated all-in-one data center

Hide thumbs Also See for FusionModule1000A:

Table of Contents

FusionModule1000A40 Prefabricated All-in-One Data

Center

Installation Guide

Procedure

Step 1 Wrap the electric heating belt around the drainpipe and water refill pipe outside the pre-fab.

module.

Figure 8-4 Wrap the electric heating belt around the drainpipe and water refill pipe

Step 2 Secure the temperature probe to the pipe using a cable tie.

Issue 03 (2020-06-09)

Secure the temperature probe to the position on the water refill and drainage pipe. The position is the

point where the electric heating belt is wrapped 50 cm long around the water refill and drainage pipe

from the water refill and drainage pipe port.

8 Installing Devices Inside Pre-fab. Modules

Table of Contents