Installation; General Requirements For Installation; Fixing The Unit To The Wall; Documentación Relacionada - Ingeteam Ingecon Sun Lite Series Installation Manual

Installation Manual Manual de instalación
INGECON® SUN LITE INGECON® SUN LITE
AAY2000IKH01 AAY2000IKI01
5

Installation

Before installing the INGECON N SUN LITE, the packaging must be removed, taking special care not to damage
the housing.
The inside of the box must be checked to ensure there is no moisture. If there are signs of moisture, the unit must
not be installed until it is completely dry.
All installation operations must obey the regulations in force.
CATÁLOGOS
Ingecon
Before starting the actions described under this point, it is important to identify each of the parts described in it and
to have gathered the necessary tools to carry them out.
PC00ISA01_A

5.1 General requirements for installation

The unit's environment must be appropriate and meet the guidelines described in Chapter 2. Additionally, the parts
used in the rest of the installation must be compatible with the unit and comply with the applicable legislation.
Pay special attention to:
- Ventilation and the space for work, which must be suitable for maintenance tasks according to the applicable
regulations in force.
MANUALES
- The external connection devices, which must be suitable and sufficiently close as laid down in the regulations in
Manual de Usuario Ingecon
force.
The connecting cables must be of the appropriate section for the maximum current.
AAY2000IKE01
Special care must be taken to ensure that there are no external elements near the air inlets and outlets to obstruct
proper ventilation of the unit.
Manual de Instalación Ingecon

5.2 Fixing the unit to the wall

INGECON SUN LITE units have a system for anchoring to the wall.
AAY2000IKH01
TL units:
A fixing plate is supplied, attached to the unit by means of a bolt. This bolt must be removed to separate the plate,
which will need to be secured to the wall where the unit is to be placed.
Manual de Instalación de los Accesorios de Comunicación
AAX2002IKH01
screw to be
undone to release
the fixing plate
AAY2000IKI01 AAY2000IKH01
Rev. _B Rev. _B
Date: March 2011 Fecha: Marzo 2011
DOCUMENTACIÓN RELACIONADA
®
Sun Catálogo Comercial
®
Sun LITE
Once the plate has been separated, follow these steps:
- Mark the attachment points for the plate on the wall. Use the template provided with
the unit.
- Drill holes in the wall with a bit recommended for the screws to be used to secure the
plate to the wall later.
- Fix the plate using wall plugs and stainless steel screws to prevent corrosion.
- The use of the appropriate screws (minimum external diameter 6 mm), washers and
wall plugs (minimum external diameter 18 mm) is recommended to secure the plate.
- Suspend the unit from the plate.
- Screw on the bottom attachment.
- Check that the unit is well secured.
®
Sun LITE
Page 27 Page 3 27