Ingeteam Ingecon Sun Lite Series Installation Manual page 15

Installation Manual Manual de instalación
INGECON® SUN LITE INGECON® SUN LITE
AAY2000IKH01 AAY2000IKI01
For TL models, the distance between drilled holes will be as follows:
80 200
CATÁLOGOS
Ingecon
PC00ISA01_A
In models with transformers, it is the transformer which will be secured to the wall. The inverter will subsequently
be fixed to the transformer.
The three upper drilled holes are made first. The measurements to be used are shown in the figure. The bottom
hole must be made when the unit is suspended, as explained in Section "5.2 Fixing the unit to the wall". The figure
shows the approximate distances between the horizontal line formed by the three upper drilled holes and where the
MANUALES
bottom hole will be. It also shows the approximate vertical distance to the level of the top edge of the inverter, which
will subsequently be attached to the transformer fixed to the wall.
Manual de Usuario Ingecon
Note: values in mm.
AAY2000IKE01
Manual de Instalación Ingecon
75 75
100 100
AAY2000IKH01
Manual de Instalación de los Accesorios de Comunicación
AAX2002IKH01
AAY2000IKI01 AAY2000IKH01
Rev. _B Rev. _B
Fecha: Marzo 2011 Date: March 2011
DOCUMENTACIÓN RELACIONADA
80
®
Sun Catálogo Comercial
®
Sun LITE
Equipment edge
150 - 165
75
240 - 250
®
Sun LITE
Page 15 Page 3 15