Message Waiting Lamp Setting-Station-Ccis - NEC UNIVERGE SV9300 Networking Manual

MESSAGE WAITING LAMP SETTING-STATION-CCIS

General Description
This feature allows the system to set or cancel the Message Waiting Lamp Indication from the station of
2400 IPX through the CCIS network.
NOTE: As for the system data assignments and operating procedures for 2400 IPX, refer to the each
manual of 2400 IPX.
Programming
START
CM13 Provide each station with Message Waiting
service.
NOTE:
CM12 Assign Service Restriction Class C to each sta-
tion.
CM15 Specify if MW lamp on Multiline Terminal
when Message Waiting is to be lit.
NOTE:
END
Hardware Required
To provide a Single-Line Telephone with Message Waiting lamp and a Multiline Terminal:
• LC (GCD-4LCF/GCD-8LCF) blade
DESCRIPTION
This command is effective only when using a Single Line Telephone with MW lamp, Stan-
dard SIP Terminal.
This command is effective only when
using the Multiline Terminal.
MESSAGE WAITING LAMP SETTING-STATION-CCIS
• Y=03
(1) X-XXXXXXXX: Station No.
(2) 0: To provide
• Y=07
(1) X-XXXXXXXX: Station No.
(2) 00-15: Service Restriction Class C
• Y=286
(1) 00-15: Service Restriction Class C assigned
by CM12 Y=07
(2) 0 : Not lit
1 : To light
1-196
Chapter 1 CCIS FEATURES
DATA
NWA-088654-001 Rev.1.0
94ch1005.fm