NEC UNIVERGE SV9300 Networking Manual page 105

Multiline Terminal
To set a Call Forwarding-All Calls-CCIS from a Multiline Terminal:
1. Lift the handset or press the Speaker key and receive dial tone.
2. Press the Call Forwarding-All Calls feature key and receive Feature Dial Tone.
3. Dial the outgoing trunk access code and receive a single burst of Service Set Tone.
(This operation is required for a network using Open Numbering Plan.)
4. Dial the desired target station number and receive Service Set Tone.
5. Wait approximately five seconds and receive Service Set Tone. The LED lights and the LCD shows:
6. Replace the handset or press the Speaker key.
To cancel a Call Forwarding-All Calls-CCIS from a Multiline Terminal:
1. Lift the handset or press the Speaker key and receive dial tone.
2. Press the Call Forwarding-All Calls feature key. The LCD shows:
3. Dial " " and receive Service Set Tone. The LED of the associated feature key will go out. The
LCD shows:
4. Replace the handset or press the Speaker key.
CALL FORWARDING-ALL CALLS-CCIS / MULTIPLE CALL FORWARDING-ALL CALLS-CCIS
SET
(TIME DISPLAY)
Forwarding station number
is displayed.
CF ALL
(TIME DISPLAY)
CANCEL
(TIME DISPLAY)
XXXX
YYY
1-91
Chapter 1 CCIS FEATURES
NWA-088654-001 Rev.1.0
94ch1003.fm