NEC UNIVERGE SV9300 Networking Manual page 172

• When no release signal arrives on the IC trunk.
START
CM08 Provide the Direct-In Termination-Outside (In
the case of no release signal on incoming trunk
and both answer and release signals on outgo-
ing trunk).
CM30 Assign the data for terminating system in Day
Mode, Night Mode, Mode A and Mode B for
the trunk, respectively.
Assign the Abbreviated Code of a station
number for the Direct-In Termination to
originate a call to the destination via CCIS, in
Day Mode, Night Mode, Mode A and Mode B,
respectively.
CM35 Assign trunk route data to the trunk route num-
ber (for IC route).
A
DESCRIPTION
(1) 324
(2) 0 : After the outgoing trunk receives the
response, the tandem connection is
allowed
1 : The tandem connection is restricted
when the incoming trunk is no restora-
tion signal
• Y=02 Day Mode
• Y=03 Night Mode
• Y=40 Mode A
• Y=41 Mode B
(1) 000-511: Trunk No.
(2) 04: Direct-In Termination
• Y=04 Day Mode
• Y=05 Night Mode
• Y=42 Mode A
• Y=43 Mode B
(1) 000-511: Trunk No.
(2) CXX
XX: 00-99: Abbreviated Code of Station
• Y=002 IC/BW
(1) 00-63: Trunk Route No.
(2) 1 : Incoming Trunk
3 : Bothway Trunk
• Y=005
Release Signal from Distant Office
(1) 00-63: Trunk Route No.
(2) 0: Release signal does not arrive
• Y=009 Incoming Connection Signaling
(1) 00-63: Trunk Route No.
(2) 15 : Ring Down
1-158
Chapter 1 CCIS FEATURES
DIRECT-IN TERMINATION-CCIS
DATA
number for Direct-In Termina-
tion in Day Mode assigned by
CM71>66
BLADE RESET
NWA-088654-001 Rev.1.0
94ch1005.fm