NEC UNIVERGE SV9300 Networking Manual page 307

A
CM35 Specify whether Dial Tone (DT) is sent to call-
ing party of opposite office when receiving the
SETUP ACK message by Overlap Sending-Q-
SIG.
NOTE:
This command should be assigned
to outgoing trunk route.
Assign Progress Description by Overlap Send-
ing-Q-SIG.
NOTE 1: This command is effective when the
second data of CM35 Y=270 is as-
signed to "1".
NOTE 2: This command should be assigned
to outgoing trunk route.
Specify whether the called party number is
sent to outgoing trunk route before receiving
all digits of the called party number in tandem
connection (Q-SIG to Q-SIG).
NOTE: This command should be assigned
to incoming trunk route of tandem
office.
END
DESCRIPTION
• Y=270
(1) 00-63: Trunk Route
(2) 0 : To send DT of own office
1 : To send DT of own office when re-
ceived Progress Description is not
same as the Progress Description as-
signed by CM35 Y=271 (Not sent
when Progress Description is same as
the Progress Description)
2 : To send DT from opposite office own
office (Not sent when DT is not sent
from opposite office)
3 : Not sent
• Y=271
(1) 00-63: Trunk Route
(2) 1-4, 8: Progress Description
15 : No data
• Y=273
(1) 00-63: Trunk Route
(2) 0 : To send
1 : Not sent
2-31
Chapter 2 Q-SIG FEATURES
OVERLAP SENDING-Q-SIG
DATA
NWA-088654-001 Rev.1.0
94ch2001.fm