NEC UNIVERGE SV9300 Networking Manual page 59

• When the setting of more than 17 Highway Channels is required for a CCT blade, reassignment of
the Highway Channel (111 ch) allocation is required to each physical slot (slot01-06/07-12/13-18).
The programming for Highway Channel reassignment is as follows. For the details of Highway
Channel reassignment, refer to "CMF7 Y=9" in Command Manual.
START
CMF7 Reassign Highway Channel to the slot accom-
modated the CCT blade.
CME0 Execute the blade reset to all slots of the Unit
accommodated the CCT blade.
END
• To execute Loopback for CCT, do the following data programming.
START
CMAA Execute Loopback for CCT.
END
DESCRIPTION
DESCRIPTION
• Y=9
(1) XX YY
XX: 01-50: Unit No.
YY: 01/07/13: Lowest Slot No. in each
(2) XX YY
XX: 01-50: Unit No.
YY: 06/12/18: Highest Slot No. in each
• Y=3
(1) XX YY
XX: 01-50: Unit No.
YY: 01-18: Slot No.
(2) XX YY
XX: 01-50: Unit No.
YY: 01-18: Slot No.
• Y=24 Loopback setting
(1) 000-127: Trunk Blade No. assigned by
00 : Local Loopback
(2)
01 : Payload Loopback
15 : Loopback OFF
1-45
Chapter 1 CCIS FEATURES
CCIS BASIC PROGRAMMING
DATA
Line/Trunk chassis (2U)
Line/Trunk chassis (2U)
DATA
CM05 Y=1
NWA-088654-001 Rev.1.0
94ch1002.fm